FAQs

What to know Designer environments allow the creation of customized UniOP fonts that can be used for example to have character sets for languages that does not use standard western ASCII tables. To ...

UniOP is providing the users with the maximum flexibility in the assignment of the IP address. There are several ways to do this and well defined priority rules in order to understand which will be ...

What to know Touchscreen component may require calibration during operator panel lifetime, calibration procedure can be recalled using two procedures: standard and emergency. Calibration procedure ...

What to know There are no restrictions to adding new communication drivers in Designer. Drivers are available upon request, please write to Exor technical support department at techsupp@exorint.it

What to know We strongly recommend to perform firmware upgrade only when this is required, please if you have any doubt contact immediately Exor International technical support department at ...

What to know We strongly recommend to perform firmware upgrade only when this is required, please if you have any doubt contact immediately Exor International technical support department at ...

What to know We strongly recommend to perform firmware upgrade only when this is required, please if you have any doubt contact immediately Exor International technical support department at ...

What to know A 422 network between more than 2 eTop300 serie panels units requires to set the slave panels communication port to work in RS485 Half Duplex (Rec-enable) mode.

What to know We strongly recommend to perform firmware upgrade only when this is required, please if you have any doubt contact immedialtely Exor International technical support department at ...